Furnace Installation in East Stroudsburg, PA
A new furnace here will run from October through May every year. Tell us about the house, and a licensed contractor who covers Monroe County will get in touch.
Tell us about the job
It takes about a minute.
Eight months of heat in East Stroudsburg
Your furnace here runs October through May. That's eight months out of the year it needs to work, with winter nights averaging 19°F. A new furnace has to be sized and installed to hold up through that whole stretch, not just the coldest weeks.
Monroe County sees real winter storms, 27 of them in the last ten years, along with 174 damaging wind events. Power outages come with that weather, and statewide, 15% of households went at least a full day without power in 2024. If your setup depends on electricity to run, that's worth thinking through when you install a new one. Any non-weatherized gas furnace built since November 2015 has to hit at least 80 percent AFUE, so that's the floor for what goes into your home now.
- 8 months
- October through May, your furnace is on duty
- 19°F
- the average winter night it heats against
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
Pennsylvania requires contractors to register with the state.
That registration puts the business on file with the Bureau of Consumer Protection and nothing more. There is no trade exam behind it, and no state license gets issued. Cities and towns in Pennsylvania are not allowed to require their own HVAC license on top of it, so this registration is the only state-level record you will find on a contractor here.
For a furnace installation, the protection that matters comes from the local building office rather than any state license. Most cities and counties require a permit before the work starts and an inspection once it is done, and that inspection is where the gas connection and venting get checked.
Source: Pennsylvania General Assembly
- What size furnace does my house need?
- The right size comes from a load calculation, not the square footage of your house alone. A contractor measures your walls, windows, insulation, and ceiling height, then works out how much heat escapes on a cold night, because a furnace that is too big cycles on and off and wears out early, and one that is too small runs constantly and still leaves rooms cold. With winter lows around 19°F here, a furnace has to be sized for real cold, not a mild average. Ask the contractor for the load calculation itself, not just a number.
- How do I know it's time to replace my furnace?
- Age is the first sign. Once a furnace gets old, repairs start costing more and fixing less, and a cracked heat exchanger or failing igniter tends to show up more often from there. Watch for rooms that stay cold no matter the thermostat setting, a furnace that cycles on and off more than it used to, or a rise in gas bills without a change in how you use it. Since your furnace has to run from October through May here, a failure in the middle of winter is worse than one in October, so it is worth having a contractor look at an aging unit before the cold sets in rather than after it quits.
- Is a high-efficiency furnace worth it?
- It depends on how much you heat and what you are replacing. Every new non-weatherized gas furnace sold today has to hit at least 80 percent AFUE, so even a standard model wastes less fuel than an old one. A high-efficiency furnace pulls more heat out of the same fuel than that minimum, and that difference adds up over the 8 months a year homes here need heat. Whether the higher upfront cost pays off depends on your home and your budget, so ask a contractor to walk through the options for your specific house.